I wanted to use a few different sources with my 6LU8, so I built a source selector in a matching chassis for my 6LU8 build. Below is a picture of them stacked:

my build journey is documented on AK:

https://audiokarma.org/forums/index.php?threads/phono-passive-selector-preamp.1042925/

I would like to add a dial face, with numbers or just lines, and some small LEDs for indicator on the selector above the switch to indicate power and selection, but most of what I am finding are too big to fit comfortably (asthetically) over the switch. Any source infor on thos would be appreciated.

by the way, the phono stage is a $10 board from Amazon. I works remarkably well for what it is, a $10 board form Amazon! Quiet, and can tke diverse power, ac/dc witha faily broad range of voltages. I have a VSPS board on order so I can compare pohono stages. I was considering an EAR clone, but the cost is prohibitive right now. The TT I use is a $20 tag sale Technics SL-BD20, with a pretty good P532 cartridge, It sounds very nice in this set up. Good frequency response, but perhaps not as dynamic as it could be.

Roger