Hello all it my first time posting here!

I Plucked up the courage to attempt to mod my A10 Amplifier following the videos on youtube.

It was an experiance and a half never done anything like this.

Well i got it Completed ran into a few snags.

Firstly i converted it to a A12 By moving one of the wires to pin 9 and bridging 4 and 5 i think it was on both sides,

I did find it very hard to change the 8.2k resistor to the 4.3k resistor on the PCD (I suspect this could be my downfall in the mod)

I do not have a bleeder resistor installed.

All the Tubes Light up!

But i have no sound.

My plan is to leave it alone for awhile and go back to it and reflow it. seen a post with low sound and a reflow fixed it not sure if it will work with my no sound symptom.

Anyway is the fact that all the tubes glow a good thing?

Or is that gonna work because i didn't rly modify anything to do with the power i guess.... anyway any insight would be great.

I'm guessing since its my first time soldering that the joints are terrible.

:D